DESCRIPTION

HyperX HX424S14IB/16 is a 2G x 64-bit

(16GB) DDR4-2400 CL14 SDRAM (Synchronous DRAM) 2Rx8,

memory module, based on sixteen 1G x 8-bit DDR4 FBGA components.

Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.

This module has been tested to run at DDR4-2400 at a low latency timing

of 14-14-14 at 1.2V. Additional timing parameters are shown in the

PnP Timing Parameters section below.

The JEDEC standard electrical and mechanical

specifications are as follows:

Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the

speed allowed by the manufacturer's system BIOS. PnP cannot increase

the system memory speed faster than is allowed by the manufacturer's BIOS.

Memory overclocking is locked at 2133MHz on all mobile processors except

Core i5 and i7 quad core processors with a TDP of 45W or greater.

SPECIFICATIONS

CL(IDD)	14 cycles
Row Cycle Time (tRCmin)	46.75ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin)	350ns (min.)
Row Active Time (tRASmin)	29.125ns (min.)
Maximum Operating Power	TBD W*
UL Rating	94 V - 0
Operating Temperature	0°C to 85°C
Storage Temperature	-55°C to +100°C

FEATURES

• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)